Free service hotline
Tel:188-2379-9985
Email:info@jtl-lab.org
Address:Area 2-1102D, Building T2, Haigu Science and Technology Building, Shiyan Street, Bao'an District, Shenzhen
Current category:Pakistan
Back to list1. Introduction to CertificationUnder the Telecommunications Act 1996 (Section 29), no terminal equipment shall be directly or indirectly connected to the public switched network unless it is of a typ
Add WeChat
1. Introduction to Certification
Under the Telecommunications Act 1996 (Section 29), no terminal equipment shall be directly or indirectly connected to the public switched network unless it is of a type approved by the PTA. Sold in general, suitable for connection to certain public telecommunications networks.
2. Certification mark
3. Product range
Wireless wifi products, Bluetooth products, telecommunications equipment, mobile phones, telephones, wireless monitoring equipment, etc.
4. Certification Standards
If the Authority has not specified any technical standard equipment for a certain terminal, the technical standards developed by the following standardization bodies can be adopted:
1. ITU Telecommunication Standardization Sector (ITU-T).
2. European Standard (EN).
3. The International Electrotechnical Commission (IEC) and its International Organization Special Committee on Radio Interference (CISPR).
4. In the European Commission for Electrotechnical Standardization (CENELEC).
5. At the European Telecommunications Standards Institute (ETSI).
6. Occupational Health and Safety Assessment Specification (OHSAS).
7. International Organization for Standardization (ISO)
8. Directive 2014/53/EU of the Radio Equipment Directive (RED)
All terminal equipment must also meet the following basic requirements and standards:
1. Valid International Mobile Equipment Identity
2. Security requirements, i.e. mobile/handheld devices must comply with specific absorption standards
5. Required information
1. User Manual
2. Schematic diagram of the circuit
3. Circuit block diagram (Block Diagram, also called module function diagram)
4. Circuit diagram (PCB LAYOUT)
5. Circuit bitmap (PCB placement)
6. Operation description (commentary to the block diagram)
7. Component list (BOM LIST)
8.label (label)
9. Antenna Specifications (or Antenna Gain Diagram)
10. Fixed frequency software (also known as fixed frequency program. It enables the transmitting module to continuously transmit at a certain frequency point. Generally, BT and WIFI must be provided)
6. Certification cycle and validity period
The validity period of the certification is permanent
7. Factory inspection
No factory inspection required
Pakistan |
· Detection content: wireless · Applicable products: wireless communication products · Whether mandatory: Yes ·Factory Inspection: None ·Local agent: no ·Plug Type: *Gauge/** Type ·Voltage requirement: **V ·Application method: direct application; certificate transfer application (** certificate can be transferred, ** report can be transferred) ·Certificate validity period: long-term ·Other supplements: |